Skip to main content
All CollectionsViewing platformsVMS GatewayInstallation
Upgrading to VMS Gateway 8.7 on Ubuntu
Upgrading to VMS Gateway 8.7 on Ubuntu

This article outlines the steps to update your existing installation to the latest release

Updated over a month ago

This article is intended for users who are currently running VMS Gateway 8.1 or above.

If you are running a pre-release version you must perform these steps instead:

Upgrade steps

These steps are the same as a fresh installation - however, your configuration is retained by the installation process.
​
Expert users can download the .deb file here if required - however, we recommend following the instructions to download and install in two simple commands.

Do you have a multi-PC installation?
​

You should perform the following steps on the primary PC first (the one running the web interface) and then on each of your additional PCs!

  • Open the Terminal application – this should give you a command prompt

  • Download VMS Gateway using this command

wget https://bit.ly/3ZVk9gl -O install87.deb

NOTE: the -O parameter is the capital letter O, and not a zero!

  • Run the installer using this command:

sudo apt install ./install87.deb

  • You will be asked to enter your Ubuntu password, and then to confirm installation.

After the installer has completed allow your system a couple of minutes before logging into the web interface. Your virtual ONVIF devices may take up to five minutes to become available as they are upgraded to the latest release.

Did this answer your question?