This article is intended for users who are currently running VMS Gateway 8.1.
VMS Gateway 8.2 is mainly a compatibility and reliability release to allow it to connect a wider range of third-party VMS - see everything that's new in the release notes.
If you are running a pre-release version or version 8.0 you must perform these steps instead:
Upgrade steps
These steps are the same as a fresh installation - however, your configuration is retained by the installation process.
Do you have a multi-PC installation?
You should perform the following steps on the primary PC first (the one running the web interface) and then on each of your additional PCs!
Open the Terminal application – this should give you a command prompt
Download VMS Gateway using this command
wget https://bit.ly/3SvXWSj -O install82.deb
NOTE: the -O parameter is the capital letter O, and not a zero!
Run the installer using this command:
sudo apt install ./install82.deb
You will be asked to enter your Ubuntu password, and then to confirm installation.
After the installer has completed allow your system a couple of minutes before logging into the web interface. Your virtual ONVIF devices may take up to five minutes to become available as they are upgraded to the latest release.