Skip to main content
All CollectionsEdgeVis encodersOur hardware productsEdgeVis EVVR-1 and EVVR-4
EVVR-1 / EVVR-4 compliance statements
EVVR-1 / EVVR-4 compliance statements
Updated over 4 months ago

Icon

CE Compliance Statement

The EdgeVis Video Router complies with the following European Union Directives:

  • Radio Equipment Directive 2014/53/EU

    • Standards: EN301 489-1 V2.2.3, EN301 489-17 V3.2.4, EN301 489-52 V1.2.1, EN55032:2015, EN55035:2017

  • Low Voltage Directive 2014/35/EU

    • EN 62368-1:2018

  • Council RoHS Directive 2011/65/EU

The use of this product may be dangerous and has to be avoided in the following areas:

  • Where it can interfere with other electronic devices in environments such as hospitals, airports, aircraft, etc.

  • Where there is risk of explosion such as gasoline stations, oil refineries, etc.

The user must ensure that:

  • The antenna(s) used with the EdgeVis Video Router must be installed to provide a separation distance of at least 20cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter

  • The antenna(s) used with the EdgeVis Video Router must conform to the requirements stated in the installation guide

  • The EdgeVis Video Router shall only be used for fixed and mobile applications

  • It is responsibility of the user to enforce the country regulations and specific environment regulations.

Icon

FCC Compliance Statement

This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with instructions, may cause harmful interference to radio communications. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following:

  • Reorient or relocate the receiving antenna

  • Increase the separation between the equipment and receiver

  • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected

The EdgeVis Video Router unit may contain a radio module that has been FCC Approved for fixed and mobile applications (FCC ID: N7NEM74B Contains transmitter module IC: 2417C-EM74B where 2417C-EM74B is the module’s certification number)

The EdgeVis Video Router may contain a radio module that has been FCC Approved for fixed and mobile applications (FCC ID: PD9AX201NG).

FCC Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

To meet the FCC’s RF exposure rules and regulations:

  • The use of a non-shielded interface cable with the EdgeVis Video Router is prohibited

  • The antenna(s) used with the EdgeVis Video Router must be installed to provide a separation distance of at least 20cm (8 inches) from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter

  • The antenna(s) used with the EdgeVis Video Router encoder, including cable loss, must not exceed 6 dBi at 700 MHz, 850 MHz, 1700 MHz and 1900 MHz; 9 dBi at 2500/2600 MHz; and 1 dBi at 2300 MHz, as defined in 2.1091 for satisfying RF exposure compliance

The EdgeVis Video Router encoder shall only be used for fixed and mobile applications.

Did this answer your question?